Odd behavior from Malin 1.1.8 and auto bed level, A8

Step by step help for new users installing Marlin for the first time
Post Reply
Mr Alien
Posts: 2
Joined: Sat Apr 14, 2018 7:28 am

Odd behavior from Malin 1.1.8 and auto bed level, A8

Post: # 928Post Mr Alien
Sat Apr 14, 2018 7:39 am

Hi. Hopefully someone here can help me, I've soured the internet to find my issue but with no success for my Anet A8.
My problem is I have enable auto bed leveling in Marlin 1.1.8 (i'll copy the config settings below) and set the probe offset, but when I try to level or home, the x axis homes correctly, but then the z axis rises three time and says STOPPED on the LCD? Very odd as it worked with older Marlin. It is probably just a setting I have overlooked, but I can't seem to find the problem. I have only changed the below settings everything else is default from the Anet marlin config files.
Any help would be appreciated. :)

Using a inductive sensor mounted on the rear of the extruder.

* The BLTouch probe uses a Hall effect sensor and emulates a servo.
#define BLTOUCH
//#define BLTOUCH_DELAY 375 // (ms) Enable and increase if needed

#define X_PROBE_OFFSET_FROM_EXTRUDER 15 // X offset: -left +right [of the nozzle]
#define Y_PROBE_OFFSET_FROM_EXTRUDER 20 // Y offset: -front +behind [the nozzle]
#define Z_PROBE_OFFSET_FROM_EXTRUDER 3 // Z offset: -below +above [the nozzle]


Post Reply